Discussion Locked

HDD PROBLEM

0 helpful
22 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I HAVE A COMPAQ DESKPRO PC IT USE TO WORK WHEN I BOUGHT IT. MY HHD CRASHED AND I DECIDED TO HAVE A NEW HARDDRIVE TO INSTALL AFTER I INSTALL THE NEW HDD I BOOT THE PC, THE THE POST THE SYSTEM IDENTIFIED THE HDD BUT IT TRIES TO LOAD THE INFORMATION ONTHE HDD IT DSPALY'S AN ERROR MESSAGE WHICH SAYS "READ ERROR" WHAT COULD BE THE PROBLEM PLZ HELP.

22 replies

by nerdy

Well this is my thought-- If it is a new Hard drive there is nothing on the hard drive for it to read. I would try installing an operating system on it.

by ann777

Use a boot disk to startup your computer

At the a: prompt, type: format c: /s

And after it formats the drive, you should be able to reomve the bootdisk and boot to your blank c: drive.

Next step would be to install your operating system.

Then you should be able to boot to Windows and install your applications.

by ann777

If you've already formatted the drive, then you forgot to put the OS startup files on the hdd. You could just do a:

SYS C:

from the a: bootdisk prompt.

by paulp

You didn't mention what model DeskPro you have, so I will assume it's an older model. The BIOS needs to be updated. Go to www.hp.com and download the latest BIOS ROMPAQ for your model DeskPro. Install it. Then try to FDISK and FORMAT the new hard drive.

by paulp

Just thought I should mention that I have done this on dozens of DeskPro 2000 Models 5133 and 5166 without any problems.

by johngreer

Depending on the HDD manufacturer, you may also need to install some drivers that came with the HDD.

by fred07

Hi, First ?? How do you know the HDD went bad and not the MB or Power Supply. Have you done a scan disk on old HDD to check for bad clusters. A bad PS will kill a HDD. Insert boot disk at startup and type at prompt, scandisk c: On old HDD. If new HDD has not been formated your bios will see it [hard written info already on HDD] but your system will not. You need to install an OS after you do a format c: from prompt [a:drive] and install your OS.
Also you will need to access your bios and make sure the HDD is properly "seen" in bios.

This discussion is closed to new replies.