Discussion Locked

HDD recognition Problems

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Pentium 100 computer consisting of the following:
CYRRIX 586 100 MHz processor on a BIOSTAR MB-8433UUD-A Ver:2 Motherboard using AWARD bios 03/06/96-UMC-881E\886B-2A4X5B08C-00 and the onboard IDE controller.
I currently have a 500Mb driveand am trying too upgrade to a 1624Mb drive
The Bios will autodetect the drive as having the correct number of cylinders, heads and sectors and state the correct size. Both FDISK and Partition Magic 5.0 will only recognise the drive as having 504Mb, The drive has 3148 cylinders but partition magic only sees 1031 cylinders thus not seeing the remaining 1Gb if drive space

If anybody out there has any suggestions please Mail them
Thanks

7 replies

by vertex

I have encountered the same problem, but on a different machine. This might help anyway. The machine is an Acer P100. It took me 3 weeks to figure it out, at BIOS setting, I have to change the harddisk setting from <504 to >504. Look if you have thesame thing on your BIOS. The reading for the harddisk size and cylinder are all correct but when it comes to fdisk and etc, it cannot go above 504 MB. You need to change the value above 504Mb before the system will accept the real value of HDD. BTW,I was installing a 2 GB harddisk on the system from the original 600 MB.

by elmo the great

Hi Vertex
You were correct, In my bios there was an option "Primary IDE Block mode - Enable/Disable" this had been enabled and was blocking the software from seeing the large drive.

Thanks

This discussion is closed to new replies.