Discussion Locked

Heat sink fans

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

What heatsink fan is best for Athlon Xp 2100+.
Is Coolermaster HAC-V81 any good or a better company is recomended?
Thank You!

7 replies

by thechas

The model HAC-V81 was not listed on Cooler Master's web site.

You can check and see if it is on AMDs recommended cooling fan list.

Cooler Master has been around for a while, and I have had no problems with their products.

I am currently using either Thermaltake, or Thermal Integration Technologies CPU fans.
http://www.thermal-integration.com/
for my socket A systems.

I have found them to be both cost effective, and reliable.

If you can stand the noise, the 7000 RPM Dragon Orb from Thermaltake does an excellent job of cooling.

Chas

by cg it

HSF assemblies are as customizable as are cases with a wide assortment available that will do the trick. There is even water cooled units that seem to become more in use these days. I use a modified Thermaltake Volcano 9. I take off the variable speed [with a very high noise level] fan that comes with it and substitute a mechatronics 80mmX80mm high speed fan. 10db less noise @4500 rpm than the stock fan and pushes 53cfm. Most HSF assemblies you buy stock either scream with a db level of 49db orbetter at 6000 to 7000 rpm and push 50 to 75 cfm or run at a paltry 3000 rpm and push 30 to 35 cfm.

HOWEVER, the type of case you have plays just as important role in keeping a CPU cool as does the HSF. The use of smaller cases does limit heat disipation from around the cpu. Couple that with using a full size AGP cards like the GF4 in a small case with the CR-ROM and power supply in close proximity to the cpu will create a box which traps heat and causes poor air circulation with the resultof a rise in operating temperature of the cpu.

This discussion is closed to new replies.