Discussion Locked

HELP Memory upgrade problem

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Have an old NEC Ready 9730/9740 PC

According to the manual the system board supports up to 256mb ram.Also says system supports 16mb by 32bit simm stick (64mb module)
I have just bought 4 64mb modules and the pc will not see 256 have swapped memory chips around installed only two at a time etc etc.
When all 4 are installed pc only see's 64mb when only 2 are installed pc sees only 32mb.
I dont think the memory is faulty but havent ruled out that possibility yet but would have thought it wouldnt boot at all if any of the chips was fauty when i place them in pairs.
Is it possible that the manual is incorrect?

7 replies

by dmiles

First check the CMOS system configuration by booting and pressing the the key to enter
Setup,look under system configuration and see if the settings are set to only 64mb,you will need to change this setting for Bios to detect more than current setting.
Also you may want to check the manufacturers web site about flash updating the Bios,you may want to check the web for a motherboard manual to check specs

by thechas

According to the memory guide at www.crucial.com your system can accept a maximum of 128MB of ram. 4 32MB simms. They recommend non-parity EDO ram.

The support site for your PC is www.priorityonesupport.com

As soulrider said, perhaps there is a BIOS upgrade, or further details.

I suspect that they didn't have any 64MB simms to test with, and the assumptions as to how they would work were wrong.

You could also check with Kingston or PNY for memory recomendations.

by silverfireiii

I have seen this on gateway computers before. When it happened to me I had to send thee memory back and get different chips. The problem is each one the black chips on the memory stick. The computer can only recognize the first 4MB of the black chips, so you need to get memory that has 16 black chips each holding 4MB. Probably eight on the front and 8 on the back. What you probably have is four 16MB black chips on the memory stick. If you call kingston they can tell exactly what chip you need. It is probably going to be very hard to find, unless they will let you order it directly from them.
I hope that this helps. Take a look at the chip and you will know if I am right or wrong. If there is four black chips, I'm probably right.If there is sixteen black chips, I'm probably wrong.

This discussion is closed to new replies.