Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Help i wanna format a 9 GB hard disk with windows nt workstation 4.0, without partitioning the hard drive?
5 replies
by bremmerz
If you create a 2 GB partition for the initial install using FDisk, and then go into Disk Administrator after you've installed NT, you can bolt the remaining 7GB onto the drive from within NT's Disk Administrator.
It's been a while since I've done this, but if you you have a look at the help section for Disk Administrator before doing so, it should tell you all you need to know.
by skylov
Thanks Pal for you help.
by schitzoid
Here a link to a tech Q&A on the same subject from last week
https://www.techrepublic.com/forumqa/thread_detail.jhtml?thread_id=59355
by admin-stuart
It's also possible to use a third party partion software such as Partition Magic to resize the system partition to use the full disk after setup.
i had kind of the same problem, i didn't want to repartion my computer and so gave up, Could you possibly help?
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies