Discussion Locked

HELP...partition table gone!

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Is it possible to repair my partition table? I was copying to my hard drive when it (the hard drive) suddenly disappeared from windows. After checking the drive, the partition table looks like it no longer exists. Partition Magic sees a partition but reports it as unallocated. Is there a way to recover my data or manually repair it? Any help would be GREATLY appreciated!

Daryl

7 replies

by jlouis45

well then u got to use the partion program in windows. use fdisk. All you got to do is boot ur computer with a bootable floppy and run fdisk. you will be prompted to choose one of the 4 options select the appropriate one and get to allocate the partion. All teh best.

by steve cody

You can use a utility such as Norton Disk Editor to manually edit the partition table data. I have manually rebuilt partition tables that were damaged by viruses and was successful. Unfortunatly, you need to know some information about the original partition to successfully restore it. You might see if you have an identical drive partitioned the same way as the one not working and look at it's partition table with Disk Editor and duplicate the information in the table.

Another method may be simpler. Just run Norton Disk Doctor on it and see if it will fix it for you. Also, you can try Scandisk, but I don't think that one is very promising.

Good luck - Steve

by drlwyk

I was going to try this but unfortunatly norton doen't detect the hard drive at all.

by shadowofthefallen

Well there IS a way, but it's rather involved. You need a dos boot disk with a dos hex editor and printer drivers (a hex editor that actually allows you to WRITE to what you're looking at). Boot with the dos disk and print the contents of your harddrive to the printer (you will need a LOT of paper). Then use the hex editor to realign your inodes by hand, with the printout as a reference.

Or you could just admit the loss of all of your data and repartition using fdisk....

This discussion is closed to new replies.