Question Locked

How can I slave my hard drive and retrieve all my info?

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I've already connected it as a slave to another computer and the drive shows but I can't access it! What do I do to retrieve all my information as this is the only place I have any of it and need it! (I'd like to thank the JAG-OFF who did this, btw....!!!)
I don't know what to do and when I had it connected as a slave the computer stated I needed to format it, which of course isn't an option when trying to save my information. But I don't know how to get the drive to open, though it appears to be connected and working when I check all the hardware on the PC. I'm ready to twitch my nose, blink my eyes a few times cross my arms and just assume it's going to be fine after I do! (Bewitched? I Dream Of Jeannie? Anyone?)
Please and thank you so much.....!!!
Oh do you need specs? So sorry...let me know.
Thanks again

4 replies

by kentontator

when the hdd is connected does it show up under disk management?

by mamies

If the drive is asking to be formatted, to me it sounds like it doesnt recognise the file system that is installed on it. Try booting the computer using knoppix (http://www.knoppix.net/) and see if you can see the drive their.

Hopefully this will be able to see both drives and you can recover your data off it.

Let me know how you go.

Thanks,

Matthew

This discussion is closed to new replies.