Question Locked

How can I turn a primary/slave HDD to primary/ master

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello, I have two hard disk drives. Each has a different installation of WIN XP. As the master (C:)is small and old enough, I want to make the secondary(F:)into primary, remove my previous C hard disk and add a new one as a secondary.
I have tried but the system don't boot (ntldr is missing).
Is there a way to do it without mess up the set up of my present F hard disk? Is there a way to keep the F even if the hard disk is the primary? (everything in regedit is set with F:\..)
Any comments would be very helpful.
Thanks

2 replies

by hal 9000

There are files written to it which allow the different installations of Windows to boot.

About your only option would be to clone your current F Drive to the new HDD and then clone your current C Drive to what was the F Drive. But if you have any partitions on the drives this [b]Will Not Work![/b]

The easiest way around this is to perform a full backup and blow away all your installations and do a reinstall of what you actually need then restore your data. It's the only method thats Guaranteed to actually work correctly.

I would suggest that you wipe any currently used HDD/s with some utility that writes zero's to every sector of the HDD/s that you intend to keep using and perform a clean install as if it was a new machine. Boot & Nuke is a good utility to perform this and is available here.

http://tinyurl.com/4rfur

Col

This discussion is closed to new replies.