Discussion Locked

How do I access a cd-rom from dos.

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an old pentium 90 pc from micron. I was having problems, so I blew away the hard drive so that I could reinstall a windows 95 system. I installed the mitsumi driver from an installation diskette. When booting the system I get the followingmessages: "ERROR: Unable to detect ATAPI CD-ROM drive" followed by "Device driver not found:'MTMIDE01" followed by "No valid CDROM device drivers selected." My config.sys entry is:
"device=C:\mtm\mtmcdai.sys /d:mtmide01"
The autoexed entry is: "c:\mscdex.exe /d:mtmide01 /m:12". I have tried several different addresses and IRQs in the config.sys. The cd-rom is attached as a secondary device to the hard disk.

7 replies

by timwalsh

The key may be the first ERROR messaage.
Enter the BIOS set-up routine at boot up and make sure the system still detects the CD-ROM. You also might try connecting the CD-ROM as the master device on the second IDE channel. While this may be basic,also double check the jumper settings on the CD-ROM to make sure they are set correctly for either master or slave.

by paulp

You said you blew away your hard drive?

I suspect you might have blown away the CD drivers as well... or at least the directory where the system is looking for them.

Do this:
Copy mtmcdai.sys and mscdex.exe to your boot diskette.
Change the line in your CONFIG.SYS file to read:
device=a:\mtmcdai.sys /d:mtmide01
Change the line in your autoexec.bat file to read:
a:\mscdex.exe /d:mtmide01 /m:12

This should work.

This discussion is closed to new replies.