Question Locked

How do I connect a 3rd eide drive to my pc.

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a new hard drive to replace my old. I need to ghost the old 10g hardrive, but to do this I need to temporarily connect the new drive (a third) to my motherboard? How do I do this? I cannot find any eide cables that allow for three drives, nor can I figure out how to manage this.

help help help

13 replies

by cg it

if you have 2 IDE channels, 1 with 2 HDDs and the other with a CD/DVD drive, hook up the 3rd drive to the second IDE channel as a master and the CD/DVD as a slave.

by gmcroskey1

thanks, I hope this works. I'm new at this updating pc stuff. :-)

by cg it

unless you have to have the CD/DVD drive for Ghost, you can just unhook the drive and hookup the HDD.

note: Primary channel is channel 1. The BIOS will list drives as primary master, primary slave and a secondary master, secondary slave.

by gmcroskey1

That means I have my drives hooked up backwards. Cause my current master is on channel 0,, Guess I'll have to fix that huh? That's what happens when a first timer builds a pc :-}

Thank you for your help. I did leave the cd/dvd drive off, don't need it. have software for ghost on main backup drive. Should work, right?

by cg it

should work ok to ghost the 3rd drive.

check your manual on your IDE channels. Some list IDE 0 as the primary, and IDE 1 as secondary.

Usually the board has 0 and 1 or 1 and 2 silk screened on the board.

by gmcroskey1

Thank you very much for your help. I've got the new drive formatting as a simple dynamic drive. About 70 percent done at the moment.

by gmcroskey1

ide channels are 1 and 2. but when in bios it states channel 0 and 1,,, odd .

I do believe 1 is the primary, cause machine would not boot when I originally hooked up new drive to channel 1 as master. asked for boot disk. so switched and now works okay.

by gmcroskey1

I completed the copy of the c drive to the new hard drive, including mbr, but pc will not boot from the new drive. Old drive was 10gb new one is 120gb. Machine will come up to the windows xp screen and then just sits, will not go further to logon screen.

Now what?

by gmcroskey1

How do I make the new drive my main boot drive. I know I have to copy the master boot record, but How do I make the computer use it for the boot up? I can't just remove the old drive and put this in it's place can I?

by cg it

if you run into booting problems see this
MS KB article on the NTLDR, Boot.ini and NTdetect.

http://support.microsoft.com/kb/315261/en-us

I've ghosted [imaged] boot drives [really single HDD systems and not run into any problems when using the image in multiple same hardware systems. they boot right up.

by cg it

might be that your using a different partition size. the BIOS will report to Windows that there is a 120GB partition and Windows says it's supposed to be 10GB.

My suggestion, Send a PM [private message to The Chas [resident hardware guru] or Hal2000 [who also might have some ideas of what to do].

I would say wipe the drive, create a 10 GB partition, Ghost, boot up, then create a second partition [or 3rd] with the remaining freespace.

This discussion is closed to new replies.