13 replies
by baxt76 Accepted solution
by cmiller5400 Accepted solution
You will need an install disk to do a fresh install or you will need to use disk cloning software to copy the drive from one to another.
Some disk cloning software would be:
Norton Ghost
Acronis True Image
Clonezilla
by sue t Accepted solution
by baxt76 Accepted solution
by oh smeg Accepted solution
And M$ is that the system makers supply a Recovery method for the OS & installed programs to be reloaded in the event of a failure.
To this end the System Makers incorporate a Recovery partition if they do not supply Recovery Disc/s.
If there is no Recovery partition or Recovery Disc's you don't have a Legitimate Copy of Windows and you have purchased from a Pirate.
Though if you have a Name Brand NB you can always contact that maker and buy a Recovery Set for your Model NB.
Col
by baxt76 Accepted solution
by oh smeg Accepted solution
Whatever software comes with your computer new as well as any additional required Drivers. It's what you need to install the OS onto a new HDD but you first need to check that it actually works.
If recorded Disc's are not stored correctly they get wiped very quickly. The obvious things to protect them from is Direct Sunlight and excessive heat.
Stick the First Disc into the Optical Drive and try starting the computer. If the system doesn't boot from the Optical Drive you need to set the Boot Order in BIOS to Optical Drive before the HDD and save the changes when you go to exit the BIOS.
The system will then boot from any Bootable Optical Disc or at the very least give you the option what you want to do. ;)
Col
by mamies Accepted solution
I would copy the recovery partition with a program like this http://ping.windowsdream.com/ (It is free and the instructions to use it on are on the site somewhere) onto the new Hard drive.
Then I would install the new hard drive into the notebook and then try and access the recovery partition.
Remember when you do this, do not format your old Hard Disk until it all works because it has your recovery partition on it.
by televerenz Accepted solution
by baxt76 Accepted solution
by oh smeg Accepted solution
Though with Acronis you need to copy the Recovery Partition First or it will not be in the correct position on the HDD.
I have used Acronis many times to Clone a NB HDD to a External USB Enclosure without any problems.
Only thing is that you need to replace Multiple Partitions in order if you use this. ;)
Col
by baxt76 Accepted solution
by oh smeg Accepted solution
No but you have to copy 2 Partitions with cloning Utilities like Acronis. As These Cloning Utilities only look at Individual Partitions they need to copy 1 Partition at a time.
So in this case you need to run the Cloning Utility twice. The first time for the Recovery Partition and if you want to copy all your Data & Settings across to the New HDD you then need to repeat the process again for the Boot Partition.
With the Recovery Partition you leave it the same size as it was and then when you do the second Partition which is what you see as the C Partition you tell the Cloning Utility to Use all of the available space left unused on the HDD.
If you don't want to copy your Data & Settings just copy the Recovery partition to the same size as it is and then boot the system off the Recovery partition and run the Windows Setup Wizard to install the OS.
Col
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending