Discussion Locked

How do I increase a Pent-233 clockspeed

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
What do I need to do to safely multiply the clockspeed on a Gateway E-3110 Pentium-233 to double or so?

5 replies

by pgcarter

A faster chip, there is no way to SAFELY double your clock speed. I can't seem to quickly find adequate docs on this machine, but there are only two possiblities. The multiplier and bus speed is software configuable (in bios screen) or there are jumpers on the motherboard. Ther is a very good site with lots of overclocking info at www.pcmech.com or www.extremetech.com. However I don't recomend this because the gains are generally not worth the risks. If you try anyway, make very sure the cpu is adequately cooled, since it is going beyond design limits colling has to be beyond design, if you know what I mean. Doubling the speed is unrealistic though you may be able to get it up to 266 or so.

by thechas

As pgcarter said, you need a faster chip.
As oppossed to the AMD and Celeron chips, the Pentium and Slot A Athlon chips. do not respond to well to overclocking, if at all.

If your motherboard is a socket 7, You may be able to use an AMD K6 processor.
You need to determine what bus speeds, multiplier, and core voltages are supported.
If the board has an Intel chipset, you are likely limited to the 233 of the chip you have.

If you have a slot 1 motherboard, you have more options.
Used and surplus slot 1 processors are going fairly cheap. Again, you need to check what bus speeds, and multipliers are supported.

I myself would suggest a new motherboard and CPU.
Once you reach 4X buss speed, you will see a very small improvement in system performance with a faster processor.
If you have a maximum bus speed of 66MHz on your motherboard, you won't see much improvement after 300MHz. The rest of the system just runs so slow, that the processor is sitting and waiting for everything else to catch up.

A new motherboard will give you;
4X APG port (you have at best 1X)
ATA100 or 133 HDD transfer rate. (at best, you have UDMA33)
200MHz to 400MHz front side bus.
Up to 800MHz memory bus.

Save your system, and wait till you can upgrade the MB.

This discussion is closed to new replies.