Discussion Locked

How do I set up an external modem?

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a proprietary piece of equipment that I need to remotely connect to via dial up modem. The equipment recently had a software upgrade that rendered my previous modems obsolete. The equipment is hard coded to use a RS232 serial interface at 9600 baud. I cannot change this. Previously it was set up at 1200 baud and all my modems were either 1200 or 2400 baud. Now, since the equipment is at 9600 baud I cannot use the prior modems because they are too slow (antiques that will not go to 9600).Can I use a common off-the-shelf modern external 56k modem (all I can find now) for this app? If so, what initialization string should I use? I can use ATS0=n&W to get the modem to answer on n rings, but cannot get any downloads. I can "connect" to the modem using Hyperterminal, Procomm, etc., but have to use a proprietary program on the calling computer to access the equipment. Hyperterminal et al will not work for this. I can get the modem to answer, but do not get the proper handshaking tones back. I think I should be able to use a common modem this way, the tech at the computer store says I should be able to, the tech support person for the equipment says I should be able to, but none offer useful info. I have tried 2 different models of Modem Blasters and an old 33k Multitech (which we use on other, newer equipment for the same purpose, also @ 9600) but with no success. As an aside, I also have'nt been able to get the Modem Blasters to work with the equipment that does work with the Multitech.
Any ideas?
Thanks in advance.

6 replies

by rcom

Does the vendor of the equipment/software suggest any specific type of modem and settings? Try to find an older US Robotics 14000 or 33600 modem they have switches that will probalby help in correcting your situation.

by jerry_owen

Have had no luck with the vendor yet. I did try an old 33600 modem, but it had no dipswitches and did not work in my application though it does work with other similar equipment that does the same functon but is newer and from a different vendor.As info, that equipment also runs at 9600. Do you know where I can get older modems? BTW, thanks for you response, even though I must rate tha answer as unacceptable it is not meant as an insult. It is just that your suggestion hasn't worked for me yet.

by djent

A word of caution on your init string question. Do not include the &w as you will consume your NVRAM write count and never write to it again.

by jerry_owen

Thanks for the warning. This is the 1st time I've heard of that. I have been doing that for several years with different modems and have noticed no problems.

by wlbowers

Get a sportster by USR. Connect it to a computer and enter your string

Set your string to dissable automode and force 9600 connect speed

N0 to disconnect automode
s37= force to connect at 9600
&y0 force use of profile 0 on powerup

continue command string until you have it complete.

Save it to profile 0 and 1.

Once you have the string successfully stored in nvram you can use ATZ0 as your init string.

Modem command strings will drive you crazy.

Good Luck Lee

by wlbowers

Just went to USR site and reviewed the new command set. They doen't use s37 now. Minimum is set by &Vx Maximum is set by $Nx

On usr type at$ to display user codes, and at&$ to display ampersand commands.

ATI4 displays current settings.

Lee

This discussion is closed to new replies.