Discussion Locked

How do you un-partition a hard drive?

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have been given a system and the Hard Drive is relatively small enough, I need to unpartition it to maximize it's capacity.

4 replies

by sgt_shultz

tell us more. is this a pc or a mac?
do you know what os?
to answer your question, assuming pc, you do it with 'fdisk' it is built into dos and windows. dir fdisk.* /s to see.
make a boot floppy so hard disk will not be in use and available to repartition. if this system boots now into win9x this is a good thing. you can make and use a Windows Emergency Startup Disk for a boot floppy (see Help) and put fdisk on it if not already.
then, assuming BIOS is set to boot from floppy first and your floppy drive works and you've made a workable boot floppy, boot from floppy and at command prompt type fdisk. you will destroy all data existing on the hard disk. so you have the os installation media so you can reinstall? if not, get partition magic to do this. it will preserve your hard disk, repartition it out from under itself so to speak. have fun.

by thechas

There are several ways to deal with your issue.

First off though, there are advantages to splitting a drive into multiple partitions.

I use a separate partition for the page file. That way, the C: drive does not get as fragmented as it otherwise would.

A separate partition for data files makes it much easier to back up your data.

Check out the article on partition planning posted at www.aumha.org

Now, to restructure the partitions on a hard drive, it is easiest if you plan to start over and re-install the OS and software.

Start by backing up any critical files.
Create a hardware profile using a utility such as Belarc Advisor (www.belarc.com) and download the drivers for the hardware.

Create a startup disk.
For Windows 98, open add/remove programs, click on the startup disk tab.
For Windows 95, you will need to download a startup disk image from www.bootdisk.com

Boot from the startup disk.
At the DOS prompt, run fdisk /mbr
This clears and rebuilds the master boot record on the drive.
Run fdisk
If the drive is larger than 2GB, answer yes to enable large drive support.
Delete the logical drives.
Delete the extended DOS partition.
Delete the primary DOS partition.
Exit fdisk and re-boot.
Run fdisk, and create partitions as desired.
(Note: for Windows 95 you are limited to 2GB per logical drive)

For more information on fdisk, check out the links at www.fdisk.com/fdisk

Your only alternative if you need / want to keep the files intact is to use a 3rd party partition manager such as Partition Magic.
CAUTION: you should still back up any critical files before using a partition manager.

One final caveat;
If the drive is too large for the BIOS on the motherboard, the drive may have been setup with drive / BIOS overlay software.
If this is the case, you may need to download the setup disk from the drive manufactures web site.

Chas

by greybeard770

FDISK will unpartition the disk but you will lose everything in the process. If you want to completely start over, that's the way to go. Products like Partition Magic will allow you to manipulate the partitions while leaving the data intact.
Backup anything of value first anyway.

by cliffl

Why havent you rated the previous answers, you only have two choices you either fdisk it and start again, losing any data, or use partion magic which will do it on the fly and you wont lose any data. Thats it folks.

This discussion is closed to new replies.