Question Locked

How to delete Windows 7 partition

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have two partitions - 1 with XP, 1 with Windows 7. The latter is an evaluation version and I would like to remove it. Before I go ahead and wipe the partition, what do I need to do to ensure the computer is able to boot (and goes straight into XP)?

Thanks for your help.

4 replies

by tmalo627

A safe way to verify would be to check your boot.ini file in the system configurator. Boot into XP, Start > Run > msconfig. Click the tab for BOOT.INI. Make sure your Windows XP installation is listed as the first OS. It should be otherwise your dual-boot wouldn't have worked in the first place.

by ---tk---

OS did you install first?

If you installed Win 7 first, then you should beable to boot into xp and blow it away. Then go to the run command, type msconfig, go to the boot.ini (4th tab) remove the part that says to boot to Win 7, so it should look something like this:
[boot loader]
timeout=20
default=multi(0)disk(0)rdisk(0)partition(1)WINDOWS
[operating systems]
multi(0)disk(0)partition(1)\WINDOWS="Microsoft XP Professional" /nonexecute=optin /fastdetect

Then downside of this is that XP, will be on the outside of the disk, which means your OS will be slightly slower.

IF you installed XP first the win 7 has control of the boot loader, so boot into XP delete the partition, then you will need your XP disk, boot to recovery mode, and you will probably have to run FIX BOOT, FIX MBR... and probably a few others...

In reality, it would probably be easer/faster to just back up your data, and reinstall XP over everything, reinstall your programs drivers, updates, and data... That is what I would do...

by rob miners

you can remove W7 by deleting the partition that you installed to, from Disk Management in XP. Windows 7 has taken over the master boot code, it will have to be fixed before XP will boot.

You can boot from the Windows 7 DVD and at a command prompt, use the following command to apply the master boot code that is compatible with NTLDR to the drive volume.

Boot from the Windows 7 DVD and on the first screen click Next, click Repair your computer, click Next and select Command Prompt. At the command prompt type in this command and press the Enter key.

bootsect.exe /nt52 c:

This discussion is closed to new replies.