Discussion Locked

How to enable sound card in DOS mode?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I would like to know how to enable sound card/sound blaster music when booting up in DOS mode instead of Windows. What autoexec.bat or config.sys settings do I have to add to do this? (I think there used to be some sort of "set blaster=..." setting, but I cannot recall what the specific command is.) If someone could please walk me through how to enable the sound card in DOS mode it would be appreciated.

5 replies

by estebandelatorre

The typical set command is:
SET BLASTER=A220 I5 D1
WHERE
A220 IS THE START MEMORY ADDRESS BLOCK
(UNDER DEVICE ADMIN/ RESOURCES/ I/O MEMORY/ SOMETHING LIKE "SOUND..."
I5 IS THE BOARD INTERRUPT (SAME PLACE, BUT CHECK THE IRQ CHECK BOX)
D1 : iS THE DMA CHANNEL MEMORY (FROM 1 TO 9) (SAME PLACE, BUT CHECK DMA MEMORY)

SOME BOARDS ALSO NEED A
SET SOUND= C:\...\CTSOUND.EXE OR CTS.EXE
THIS IS A DOS COMPATIBILITY FILE WHICH FORCE THE PNP HARDWARE TO USE THE SETTINGS SAVED UNDER WINDOWSTHE ENVIRONMENT.

HOPE IT HELPS

This discussion is closed to new replies.