6 replies
by kees_b edited Accepted solution
by rproffitt edited Accepted solution
by birdmantd Accepted solution
by garloom26 Accepted solution
by oh smeg edited Accepted solution
Which means to the layperson No Moving Parts in it so if it is an internal fault then you are going to be unlikely to be in a position to fix it as it can only be soldering that has failed and you can not afford the soldering equipment needed to attempt any sort of repair. If you attack it with a conventional Soldering iron you'll kill it by overheating the IC's burning the copper tracks off the substrate or in extreme cases actually setting the Circuit Board on Fire.
The other thing is that the soldering points are small so you'll need a very small temp controlled soldering iron to even begin to attempt a single solder joint and you'll probably join several together shorting out the drive itself.
However if the problem is on the circuit board on the bottom of the drive it is possible to replace that Circuit Board but as the drive makers do not sell then you'll need a working one from the same make, model, size and revision as the SSD you have which generally means hunting around second hand shops till you find what you want and then having a stable enough hand to remove the circuit board without damaging it and fitting it to the non working one without doing any damage.
The easy answer is to go to a data recovery house give them the drive and see what they can do with it. It may be an easy fix to recover the data off it or it could be a expensive fix I've seen Data recovery houses charge between a couple of hundred $ to several hundred thousand $ depending on what has happened to the drive. No matter what it will instill into you to BACKUP everything constantly as no drive is going to work forever some do not even last as long as what their makers claim as a Warranty Period and all that they provide warranty on is the hardware the data you have put onto the drive is your responsibility and it's up to you to make sure it is safe.
Way too many ways for HDD's to corrupt data in normal use without throwing in hardware failures so the cheapest way to save your Data is BACKUP, BACKUP, BACKUP and then BACKUP again and even then there is no grantee that the net computer you plug that backup drive into will be able to read it depending on how long that drive has been sitting in it's storage area. I've seen IDE Drives that are not a standard layout so what should have been an easy copy and paste turned into a nightmare trying to find a system that could hold one of those older drives and copy it to another drive that was usable in a more mod
by birdmantd Accepted solution
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending