Discussion Locked

how to format a hard dirve?.

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi there:
I have originally a pata drive as C: dirve and now I added a new drive as a sata drive. When I connected them to my motherbord that's Intle D865GPF, I insured that the settings were sat at auto or enable and it indded it detected my both drives C: as sat dirve and pata drive as pata drive. My scrwed up started when I wanted ot install Windows Xp. I commanded to format D: dirve and it did and as you know it has to copeis some windows files for installation prepatration. I deleted D: partition to go ahead to install Window Xp in sata dirve. When I booted my computer to have fresh start the lay out of my dirves as D: pata at the top and sata at the bottom. I went ahead and installed Windows Xp in my sata drive and guess what, my computer became very slow during the boot process. I try to figure out what the cause was by accessing windows setup a gain and this what i saw D: pata dive at the top and my sata drive at the bottom. It seemed to me eventhough I deleted D: partition but it was still keep of the Windows Xp files. I now disconnected my pata drive and left with sata drive and my computer up to it's speed again. What I would like now is to have an idea of "How to format my pata drive and connect it with sata drive?.

Thanks.

2 replies

by hal 9000

Well the first thing to do is wipe the IDE Drive and then fit it to the computer. That will allow you to boot from the SATA drive and then open the Control Panel click on Administrative Tools then Computer Management and when the next window open click on Disk Management scroll down if necessary to the HDD you want to format and Right Click on it and chose the Format Option.

That will get the drive formatted and running as a Slave or secondary drive to the SATA.

Col

This discussion is closed to new replies.