Discussion Locked

how to install a 3rd ide device

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hi, I would like to know how do you install and configure a 3rd IDE drive. I currently have a 52x cd drive and 1 40 Gb HD installed. On my motherboard there are 2 ide connector (primary and secondary). I want to add a CD-RW and not replace my current 52xCD which works fine.

3 replies

by dmiles

Check the configuration of your current drives
The hard drive will be setup on the primary controller,then your cd-rom could be set as slave to the hard drive on the primary controller

If this is true then you can configure the CD-RW as Master by setting jumpers on the back of drive,then plug the Secondary controller to the CD-RW
You donot have to replace the CD-ROM it will be fine to leave in the system as a slave to the hard drive or the CD-RW

Open the CMOS panel and check configuration panel to make sure that drive is being recognized

Also reference the manual that comes with the CD-RW which will provide you with installation instructions

This discussion is closed to new replies.