HOW TO INSTALL HARD DRIVE TO WINDOWS
I want to install a used hardrive but there
is no dos o/s suspect different o/s used prev
. will not detect on ide cable how can i force detection or erase prev. o/s.
Hardware
I want to install a used hardrive but there
is no dos o/s suspect different o/s used prev
. will not detect on ide cable how can i force detection or erase prev. o/s.
by jimbb
Two different issues here. If you create a bootdisk with DOS6 (try www.bootdisk.com), you can use fdisk to remove any DOS or non-DOS partition using FDISK. No partition=no OS.
Howver, if you cannot detect the disk at all (not even with errors about being not formatted or so), you should fix that first. Is it cable select aware? Old stuff not always is. Maybe you should check the master/slave jumpers?
Jim
by kemhart
by jwilczyn
1.Try to detect this HD in BIOS (remember jumpers master/slave, primary/secondary IDE controller).
2.If it is detected by m/b (BIOS), boot to DOS mode and run "fdisk".
3.Using "fdisk" delete the current partition on this HD and create a new one.
4.Restart PC, go to Win and check HDs - if you can see it - format it (it?s quicker than under DOS)
Good Luck
by kemhart
by freetech
a slick little utility called delpart will erase any partitio off of a hard drive. get it at http://www2.netquest.com/tech/MyPC/utilitie.htm
then you can run fdisk to partition it for windows.
by kemhart
by kemhart
This discussion is closed to new replies.
Sort by Trending