Discussion Locked

How to remove bad sectors from harddisk.

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

hi,

I have two 20 gb harddisk of seagate and samsung.There are lots of bad sectors in it.I want to remove the bad sectors from the harddisk.Is there any utility which removes the bad sectors from the harddisk.

Regards.

Anurag.

5 replies

by carollong

It depends on why the sectors have been marked as bad. Some manufacturers will make slightly larger discs than their official spec and sacrifice a little quality to keep manufacturing costs down. This extra size allows for physical problems or damage on the disks that will be marked as bad sectors when it is first used. You cannot do anything about those.

Some older windows software (for things like security files and file compression) would use the short cut of marking a sector as bad to?hide? it from the user and use low level commands to read the disk. Most of these have found other ways because this sort of behaviour is assumed to be the actions of a virus in modern software. Some of these applications will remove the files andclean up the marked sectors when you use the tools provided with them or uninstall them.

If there are a large number of bad sectors and the disk is old, consider that there may be a big problem with the drive. The read/write head may have crashedon to the surface of the disk (either due to a failure or bad transportation) damaging the disk. Then it is time to replace the drive.

by thechas

A bad sector is an indication of a problem with the magnetic media on the hard disk platter.

In my experience, 90% of bad sectors return after they have been recovered.

If you format the drives, the bad sectors will be marked as bad, and skipped, they will no longer show up as bad sectors when running scandisk or defrag.

The best way to attempt recovery of bad sectors, is to use the drive manufactures low level format utility.
CAUTION: ALL DATA ON THE DRIVE WILL BE LOST!!!

Alternately, you can try things like Disk Doctor in Norton Utilities.

Chas

by fred07

You should BACKUP NOW anything you do not want lost. Bad sectors on HD's migrate both forward and backword and do spread like wildfire sometimes.
When a utility "repairs" bad sectors it merly hides them hence "the spread" occurs.
If a little dust is in there it can "move" to good sectors.
BACKUP NOW and replace the HD,s unless your data is not important.
Remember "Murphy's Law" at the worst possible time those HD's will fail completely and no recovery. I should not say "no recovery". I start at $5000.00 and it goes up from there and it will be in my hand [the money] before I start.

by wlbowers

Sectors are marked bad because the drive had trouble reading data from them. You just can't remove them and keep going.

Most manufacturers have diagnostic and/or recertification software on their websites.

I know that seagate has SeaTools.Running this software will as the oems say recertify your drive. If the sectors are recoverable they will be. If not they will be mapped out and the size of your drive will be reduced accordingly.

Note all data on your drive will be erased when this operation is performed. So back up.

Good Luck Lee

This discussion is closed to new replies.