1 reply
by thechas
Start by checking the DMA / UDMA / Mode setting for the hard drive in BIOS setup.
If DMA mode is set to auto, make sure that no slower devices are connected to the same IDE channel (cable).
Do not manually set the DMA mode to a higher rate than the drive supports.
While in BIOS setup, verify that Cache and system memory settings are properly configured.
Next, check EVERY device connected to the data bus on the motherboard. This includes modems and network cards.
A bad or improperly configured plug-in card or on-board device can hog the data bus, and slow down ALL data transfer.
Low voltage on the power supply lines can also cause poor system performance.
One way to verify if you have an IDE controller problem or a system bus problem is to use a PCI IDE controller card. If data transfer improves with the card, then the IDE controller on the motherboard "MAY" be failing. If data transfer stays about the same, there is another problem on the bus.
Chas
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending