NEVER USE ALCOHOL ON JET PRINTERS. For this one you use a dry cloth. For most of the others just a damp cloth with plain water.
Troubleshooting.
Turn off the printer.
Disconnect the interface (parallel, USB, network) cable.
Remove the printheads and make sure the protective tape has been removed. Check the expiration date and make sure the printheads have not expired.
Remove the ink cartridges and make sure the protective tape has been removed.
Install the ink cartridges and printheads.
Still have an error,
Remove all the printheads from the printer and clean the electrical contacts on the back of the printheads with a soft, DRY, lint-free cloth.
Turn the printer off and clean the corresponding electrical contacts in the printhead receptacle in the printer with a cotton swab.
Install the black printhead.
Turn the printer on.
Press and hold the POWER button on the printer for four seconds to generate a printhead information page. If the page fails to print, if all the lights on the printer start to flicker rapidly, or if information about an installed printhead is missing from the page, the printhead may be defective and should be replaced.
If the printhead information page shows that the installed printhead is present it should be okay.
Remove the previously tested printhead, insert the next printhead to be tested and repeat these steps for each printhead.
If all the printheads test well individually, install all the printheads. Hold the POWER button down for four seconds to print an HP 2000C diagnostic test page. This page should indicate that all the printheads are working properly.
If the ATTENTION light continues to blink and pressing the RESUME button has no effect and all of the steps above have been completed, the printer may require repair