Discussion Locked

HP 5000 print quality problems

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
On a landscape page the output on the left 2" or so is very faint. Have replaced the tone, transfer roll, fuser kit, and altered the print quality settings. Makes no difference. It is the same output even trying a test page from the printer. Does anybody have any other suggestions?

5 replies

by dmiles

Check to make sure that the cable is connected properly and you have the updated driver,then use the page setup to view the proper setup funtions,use the print preview to check page before printing

by robbi61

If you had the same print problem with a test page from the printer itself ( I'm assuming a configuration page), then you most likely have a laser scanner problem. I'd suggest cleaning the optics with lint free cloth and alcohol, check your laser cable connections. If that still doesn't do it, the Laser is probably bad. To clean the optics on the laser, you'll need to remove covers to get inside the top cover, then remove the cover of the laser assy. You'll find mirrors and a glass prism. These are what should be cleaned. Make sure the printer is OFF ( unplug for safety) before opening the laser assy.

This discussion is closed to new replies.