Discussion Locked

HP 5si Laserjet network configuration

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Does anyone know how to set the IP address on a HP Laserjet 5si? I have it set now, but need to change the IP address. Forgot???

9 replies

by todd

Print a test page. Look in the MIO section and it will tell you the ip. You telnet to that ip and make you changes. You can also download Jet Admin from HP and use that util to change it also. I find the telnet to be quick and strait forward

by dcosgrove

You can use the JetAdmin tool but an easier and quicker way is to do it right through the printer control panel. There is an option, I'm sorry I can't remember the exact menu terminology, to set a static IP right from the printer control panel itself. I think it's under the menu opion for Network Config. Then I believe it's a menu option called IP Address. Press select on this and you will be able to give it any IP address you want. Some times, JetAdmin can give you a hard time, especiallyif you're running a novell network. If the IP is static, I would suggest setting it from the printer control panel. Good luck.

by robbi61

Before you change the IP address, print a configuration page for a back-up in case you need to go back to the original configuration. To configure the IP address statically through the control panel, you go through the menu button til you get to the MIO menu for the MIO slot where your jet direct card is installed, either MIO 1 or MIO 2. Then item. It will ask if you want to configure the MIO. Change the answer from no to yes, then select. It will offer several choices. I take it since you are asking about changing the IP address, that you have this installed on a TCP/IP statically configured network. You will want to change a no to yes and select when it asks to configure TCP/IP. Leave BOOTP/RARP turned off. It will then ask for the IP address, default gateway, subnet mask, etc. each one of these is configured one byte at a time.(dotted decimal ie: 255.255.255.255, each 255 being a byte). Be careful, you can only plus through these numbers, so if you miss your target numberin each byte, you will have to take it all the way back around til you get back to the number again.

This discussion is closed to new replies.