Discussion Locked

HP 660cse Printer Problems

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello,
I just reinstalled an HP660cse and on one computer I get "no Communication" errors. This has been reinstalled 5 times with new downloaded drivers from HP. The cable has been switched with new and known good cables. When installed on another computer I get "Out of Paper" errors. The printer does its own test page print, but will not print a test page from Printer Properties page because of the lack of communication. The drivers have been downloaded from the net 4 different times.
THANKS!!

5 replies

by mike jones

Try downloading an older version of the driver.

We had a similar problem and could only get it to work with an older driver.

HP normally have a few older revisions on their website.

by martyl

You don't need to download new drivers - if the port is ok then you can use the Add Printer Wizard and install the HP DeskJet 550c driver that's already on your computer. That driver will make it work. Verify the port first - connect the printer and boot to DOS mode then type "dir > lpt1" (without the quotes, of course) and see if anything comes out of the printer - if not, repeat the command. If nothing happens at the printer, there should be an error message on the screen. Also make sure you're connecting the printer DIRECTLY to the PC without ANY pass-through device of any kind - no adapters, switchboxes, etc. If you DO get an error when sending a print command from DOS, something's wrong with your parallel port.

This discussion is closed to new replies.