Discussion Locked

HP laserjet III Network Adapter

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
The adapters in my Laserjet III's are set up for Novell. Are they configurable for TCP/IP (and how?), or does that warrant replacement?

3 replies

by idtent

if memory serves - you most likely have a jetdirect card - on the lcd of the printer you should be able to turn on tcp/ip by going to the config option and pressing the select ( to remove the * from the right of the disabled - it might have a dummy ip like 192.0.0.192) and set up TCP/IP - I think thats right - I know it is for a laserjet 4si
print out a configuration page from the test menu and see what it says - also print a menu map for that matter - good luck

by redshift

Good answer, but the Laserjet III series isn't nearly as advanced as the LJ4. I pulled the Jetdirect card out of the printer, and NOVELL ENET/802.3 with a MAC address is on a label stuck to a large removeable chip.

I guess 10base-T doesn't implyTCP/IP.

This discussion is closed to new replies.