Discussion Locked

HP Printing

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We have a HP Laserjet 4m+. It randomly gives us an error code of 41.3 right in the middle or at the end of printing a document. It is not page specific. However when the error code pop's up, once we clear the message it starts printing codes instead of what it is supposed to print. The suggestions I got from HP's website and the manual did not help. I even replaced the pick-up rollers and that did not work. Any advice would greatly be appreciated. Thank you in advance.

11 replies

by timthetoolman

Hi,

I'm not sure what suggestions you've tried but try using better quality thicker paper.

This seems to be a common problem for your printer.

Cheers,
Tim.

by ann777

Here's what the manual says for all models of printers for 41.1 or 2 error, 41.3 error:

1) There are defective connections... reseat J205, j206, and laser scanner connections.

2) There is a paper multifeed or the wrong size paper is being used... see service notes c2001A-01 and -02 (for LJ4 and 4+).

3) The paper size selection does not match the installed paper.

4) One of the cassettes is overfilled or improperly adjusted... remove the paper from the cassette . Readjust the cassette.

5) The paper does not meet HP specifications.

----
Because #2 above suggests that part of the problem may be a paper multifeed, I suggest thouroughly going through the paper pickup rollers and cleaning them with 75% or less, rubbing alcohol. Pay attention to any rollers in the paper tray itself too.

by jwilczyn

Check your printer settings ? paper size ? A4/letter.
Next check the paper settings for this printer in PCs.
A document could be created in A4 size and sent to the printer, where the default paper size is ?letter? (and vice-versa), what can cause this error.

by Former member

Observation: I have seen code printout when postscript drivers were used on a non postscript platform.

Suggetion: If your output does not require the Postscript Simm, remove it try printing as a plain jane 4+.

This discussion is closed to new replies.