Discussion Locked

hp scanjet 2200c driver

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

o/s : amd athlon 900mhz,192mb ram,20gb h/d,windows me.
everything was working fine then the video card shit itself.i replaced same with nvidia g force 2 64mb card and installed all the hardware but the problem is windows me wont let me install hp driver for hp scanjet 2200c scanner.
when windows me auto detects the scanner it puts it's own drivers on and it shows up in device manager as unknown device with a red x . it does not show up as an image device. ? is the driver windows me puts on WIA supported and also are the hp driver [sj646en.exe] wia supported. This scanner [with sj646en.exe]was working fine before.I checked the IRQ's and it does not seem [to me] to be allocating an IRQ for the scanner.
I hope i have supplied enough info.please help.

3 replies

by thechas

Are you using the latest Hp driver for Windows Me?

See this link http://tinyurl.com/65ko
for the latest (US) version of the driver.

The driver is 500K, the software is 42MB.

Here is a link to the setup FAQ page.
http://tinyurl.com/65ktAre you using USB or Parallel connection?
Either way, the scanner does NOT need an IRQ.

If you are using the parallel port, make sure that the port mode is set to ECP/EPP.

I know for my scanner, the printer must be on for the scanner to work.

If you are using the USB port, you may need to re-install the USB drivers for the chip-set on your motherboard.

Also, for most USB devices, it is recommended to install the software / driver before connecting the hardware.

Chas

This discussion is closed to new replies.