Discussion Locked

HP670c Printer Problem

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

When I try to print a document, the paper goes inside the printer, but stopped before any printing is done. Sometimes, the page is just half printed. Then a message appears on the screen: Lost communication with computer.
I have checked my cable onother printer, it works fine. The most annoying part is that, my printer turns alright some time after it fails to do the previous printing job.
Can somebody help me to solve the problem?

Thanks in advance.

7 replies

by Member 20229100

Two items; what are your system resources running at, one thing you can try, go to the spool settings and give "raw" a try. See if it runs like that, just run a test page while you are there. Good luck!

by jlouis45

well there are 2 things you can do one is select print jobs after 1st page is spooled and see that the data is RAW format. Or you can check print directly to printer (without spooling). Also check the port status before printing.
ALL THE BEST

by gmarufu

Well if all advice have failed, then I suggest you send the printer for a thorough printer service at your service providers. When the printer comes back and before you use it uninstall the printer software and restart the computer. Your computer is bound find NEW HARDWARE after restart. Reload the software with the printer connected to the computer. Select the default settings for the printer on installation. I hope that works.

George Marufu

This discussion is closed to new replies.