Discussion Locked

hub of the problem

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,

Got a prob. with a 2K(SBS) network, where 9 or so clients connected through
a hub.

The hub goes down at periodic intervals, which vary (at present every 10
mins past the hour!)(link lights say on). No virus on server. Multiple
(different) hubs tried.

The only way to recover the hub is to unplug/plug in the power.

Any suggestions, or need more info?

Hope u can help.

TJ.

8 replies

by ryannsit

Make sure none of the cables are run over florescent office lights. Test cables.

Is it shielded Cat-5?

by bcbvale

Try using a sniffer to see if a "chatty" device is causing congestion. This might explain why unpluging the hub clears the problem since it would clear all network traffic.

BCBV

by william jay

Howdy,

Sounds like the hub is plugged in on a circuit with a large intermittent load. Air conditioners, water coolers, refrigerators, fans, or things like that. Mission critical electonic systems need clean clear power, usually provided by an Uninterruptible Power Supply, (UPS), or other line conditioning equipment. Wires that pass close to other electric systems can cause it too, so check the network wiring paths and physically inspect the cables for damage . . .

by hhernandez

You did not mentioned what type of switch. If it is a cisco, you need to configure the port that the switch uses to connect to the hub to not use portfast. STP prevents loops. It sounds like the hub keeps resetting the port on the switch. if the switch is not manageable, consider replacing the hub with a switch. a small linksys switch would do.

This discussion is closed to new replies.