Discussion Locked

I CANT USE MY CD OR FLOPPY

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I HAVE A OLDER AMD K6333 ON A MACHINE IVE BEEN WORKING ON.ON INITIAL BOOT UP THE MACHINE SEES THE CD AND FLOPPY,WHEN I GO TO SYSTEM DEVICES THE TWO ARE WORKING PROPERLY AND HAVE NO CONFLICTS.WHEN I TRY TO WRITE OR READ FROM THEM THE ARE NOT ACCESABLE AND CANT BE USED.PLEASE HELP IF POSSIBLE I LOOK FORWARD TO HEARING FROM YOU
THANK YOU
CHRIS WILCOX

7 replies

by thechas

Start by making sure that the chipset IDE bus-master driver is installed and up to date.

If the Motherboard has an ALI chipset, I know for a fact that you cannot access the floppy and sometimes the CD drive if the IDE bus driver is not installed.

The next step would be to delete the drives and controlers from device manager. (Make sure you delete the IDE root hub)
Re-boot, and let windows re-install the drivers for the IDE system.

Chas

by zlitocook

Ok start from the top, is there a virus scaner on the system? If not install one because that is one of the things they do is not let you get to floppy or other drives. Back up the needed files and format the drive and reinstall with the virus scanner first. If it still does not work check the connections and cables, replace or try known good ones and try a second time. And please type in lower case.

by sats18

Try doing the following.
# Discharge ur CMOS battery. The new settings will be detected and stored.

# Remove the devices(Hard disk and floppy drive) from the control panel and give refresh. The devices will be detected.

# Try installing the .inf files from the CD which came along with the motherboard.

# Final one, try booting with a Win98 /ME startup floppy and try accessing. If not take a backup of important files and re-install ur operating system.

Sure these will help u.

This discussion is closed to new replies.