6 replies
by simy
by edlockett
by dmiles
Go back and recheck all the cable connections to the motherboard and to drives,make sure that cable is on properly.
Check the ram to make sure modules are seated properly.
Check the CPU fan to see if it runs when you boot computer,make that it was seatec correctly and you did not bend any of the pins
After check the connections and hardware,then you may want to consider that motherboard needs to be replaced,the one thing you did not mention in your post.
by thechas
Check the setting of the Clear CMOS jumper.
Some motherboards ship with this jumper set to clear.
If the CMOS jumper is in the normal position, try clearing the CMOS as this often helps the BIOS get a clean start to properly detect the CPU.
I have also had problems from case and CPU fans plugged into the motherboard.
Some generate electrical noise on the RPM output that causes problems for the motherboard.
Don't forget to make sure that a mounting stud is not shorting to the motherboard.
Chas
by g.brown
OK, I had a really annoying one like this.
It ended up that an IDE cable was knackered.
Once the board got very confused it would not start up until I had reseated the CPU.
It took me a while to figure out that it was the IDE cable (the only thing that gave it away was on the BIOS screen when it detedted the HDD it did not come up with the name of the HDD .. just a load of garbage) though and was very frustrating as it would boot up OK for a while but thern just lock up and not restart (giving same problems as you ... lights on but noone home).
Unplug everything from the PC.
Then just reconnect the Vid card, CPU (and fan) and Memory and see if it boots then.
by amartya07
DEAR IF YOU KNOW ASSEMBLING THEN OPEN ALL COMPONENTS AND REASSEMBLE . DO CHECK FOR RAM SLOTS
THE PROBLEM I THINK LIES WITH YOUR RAM / RAM SLOTS
OR SOME IC CHIP OF YOUR MOTHERBOARD MIGHT HAVE BURNED
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending