10 replies
by jus2sho Accepted solution
by hal 9000 Accepted solution
As one of the IDE Drives is the Default Boot drive you need to copy the necessary files to it to allow the computer to be pointed to the SATA Drive to boot from.
Col
by jus2sho Accepted solution
by hal 9000 Accepted solution
You placed a pointer on the Boot Drive to the position of the OS. Now that you want that OS to be in a different position you need to change the pointer to the SATA Drive and install the SATA Drivers if required in the initial setup of the system.
If you disconnect every IDE Drive the OS will still not boot off the SATA Drive will it? That is because the correct drivers and other necessary items are no longer present but you can get by with a repair install by following the directions here.
Col
by dumphrey Accepted solution
by jus2sho Accepted solution
by hal 9000 Accepted solution
Becomes the Default drive and needs the files to point the computer to the Windows Boot Files.
As you can remove the IDE Drives and have the system boot you must have a NVidia Chip Set M'Board right?
Col
by jus2sho Accepted solution
The Mboard is a Soyo SY-P4I865PE Plus DRAGON 2.
http://www.soyo.com.tw/products/proddesc.php?id=238
by hal 9000 Accepted solution
I've never seen a Intel 865 Chip Set M'Board that didn't need SATA Drivers to work. Anyway as you can install the SATA Drive and have it work or the IDE Drive and have it boot off that but you can not have both if you remove the Windows Folder from the Primary IDE Drive the computer will stop booting as it lacks the necessary Road Map to point the computer to the correct location for the Windows Files to boot from.
Wipe the IDE Drive and then run a Repair/In Place Install and you'll be working without a problem though you will most likely need the SATA Drivers copied to the Root of a Floppy when you perform the initial install.
Col
by stevethewirepuller Accepted solution
I had two IDE's and also just added a SATA to the same MOBO.
It did boot to the old IDE master. But I didn't try to get around that, I simply put the drive in an external USB enclosure after copying everything I urgently wanted to the SATA.
I would imagine you would just go into Tools and get rid of the boot partition. This would also delete any data of course.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending