8 replies
by n_delorme_04 Accepted solution
by dma69593 Accepted solution
The first thing you did was correct in that you set the new hard drive as slave and connected it to the same IDE cable. So go back and do this again. To get your second hard drive noticed you need to configure and format the hard drive.
To do this go to Start, then Control Panel, then switch to Classic View, then go to Administrative Tools, then Computer Management and then Disk Management.
Look in the graphical area in bottom right of window:
Disk 0 = original Hard Drive
Disk 1 = New Hard Drive
If it says this above, this means that the drive is probaly not formatted. So, click on the small button to initialize the drive, and then format it as an NTFS (see below for more details on this) volume (right click on new drive, then click 'format...'). Formatting may take an hour or so.
Once done, disk is ready to use.
About NTFS. I'm assuming you have XP.
If you are using Win '98 you need to use FAT16 and not NTFS
by n_delorme_04 Accepted solution
by ugadata Accepted solution
When you say the computer doesn't detect your second hard drive, how are you determining that it is not detecting it?
Do you see it as part of the text screens as the computer boots? If not then you may need to check the BIOS settings and verify the setting for primary master and primary slave, specifically the slave setting in this case may be set to NONE.
However, if the drive is being seen as the system boots, then follow the advice of the previous post.
by n_delorme_04 Accepted solution
by ugadata Accepted solution
If the hard drive is not recognized by the motherboard or add-in controller, there is nothing the OS can do about it. The Recovery Console will not help. The hardware doesn't care about formatting or if the drive is wiped clean.
Do you see the drive as the system boots? If quickboot or silent boot is turned on you may not see the boot up messages.
It is also possible on some motherboards to manually auto detect the HDD from with in the BOIS itself.
Presuming the cable is OK, you may want to double check the master/slave jumper settings or set both drives to cable select and the hardware work it out.
by n_delorme_04 Accepted solution
by dma69593 Accepted solution
Uh... Operating systems are not portable. You can't install XP on this second hard drive and then transfer it to another pc.
This is because the sys files are stored in the BIOS settings.
If you wanted to place this second HD in another pc, why didn't you just do that?
Another thing to take note of is that if your xp disk is genuine Microsoft, its not wise to install it again. MS keeps tracks of its registered products and keycodes.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending