Discussion Locked

I need help with a USB Scanner install

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am attempting to install a HP Scanjet scanner (C6270A) on a W98SR2 PC using the USB port on the PC.
Naturally I can't find documentation on this. Information on connections via a SCSI port is available. The HP web site doesn't even recognize themodel. It took some digging to discover that I can use the 6200 series drivers.
Someone point me in a direction please. What steps are needed for USB installation?

8 replies

by richard_barsby

Hi with most usb devices that I have come across you have to install the software then power off connect the device and power up then windows finds the device and sets it up.

Hope this helps

Rich

by jctech

My experience with USB has been that you do not power off to connect the device to the USB port. First, make sure the device is not connected to the USB port, then install the software. Once the drivers are installed, the setup should prompt you to connect the device to the USB port WHILE THE COMPUTER IS TURNED ON, then if all goes well, windows should detect the device at this point.

by hiranyaw

I installed a HP USB scaner last month. you have to install drives before you connect the USB cable from the scaner to you computer. but if you have windows Me it might recognize the usb scaner. even with out
drives install.

This discussion is closed to new replies.