Discussion Locked

I/O.SYS

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
When I boot my computer I get a I/O.SYS is missing or damaged message and can't complete the boot process.What can I do?

9 replies

by opatzg9

Alpha -male was right as is the next one, to make a drive bootable with DOS,win9x,me,... you need the system support files which are attributed with hidden, read only and system. They were put on your drive with
Sys C:
to make c: bootable
Hidden files include io.sys, msdos.sys
and then there is the command.com which holds a good collection of your DOS commands.
Now why the io.sys is missing may be a whole diferent problem. Hard disk crash, bad sector, boot virus. Sometimes a sys c: does not work, there's something about boot sector files needing to be somewhere specific and since they are not writing back there, there might be a problem with the drive or data sectors. Nortons utility software diskdoctor/windoctor has an option to make a disk bootable which would fix this.

by rcom

You're not supplying enough info here and the fact that you haven't answered with what happened after trying the suggestions and only rejected the responses makes it difficult to assist you with YOUR problem.

What is the computer info, CPU, sizeand type of drive, operating system etc.

First, if you boot to a floppy disk can you see the C drive at all? Type C: then hit enter. This will change to the C drive. The screen should show a prompt of C:\> If it says anything about the drive specification doesn't exsist then you may have disk management software installed. If that's the case reboot without the floppy and keep an eye out for a message that prompts for what key to hit to boot from a floppy insert the floppy then do that.

Can you see the contents of the C: drive? Type in DIR and hit enter. The screen should then show the folders and files on the drive. To see if the I/O.SYS file is on the drive type DIR I/O*.* /a then hit enter. Delete the current I/O.SYS by typing in attrib I/O.SYS -H -R -S then hit enter. After that type in DEL I/O.SYS hit enter.
Change back to the A drive by typing in A: hit enter. Type in SYS C: hit enter.

This may be caused by a virus. Get yourself a bootable virus scaning disk and check the drive be sure to write protect the disk by opening the tab.

This discussion is closed to new replies.