Question Locked

IBM GL300

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a IBM GL300 that the hard drive was making alot of noise and needed to be replaced. I replaced the drive and wanted to boot up off the CD and I did not see boot up on CD as an option. I can boot up from the A drive but attempting to access the C: drive it says that nothing is found.

Need to adjust the BIOS to boot from CD and any suggestions about the hard drive.

2 replies

by hal 9000

What was the size of the HDD removed? And what was the size of the replacement Drive?

It's possible that you have exceeded the ability of BIOS to see the replaced HDD which should be the C Drive.

Also when you replaced the Drive did you enter BIOS and change any settings in there for the HDD so that it can be seen? As IBM doesn't have a massive collection of Manuals to download I'm not sure what's involved here but you'll need to refer to your Users Manual and check the max size of supported HDD and how to change the HDD configuration in BIOS.

Col

This discussion is closed to new replies.