8 replies
by csmith
The most common way to solve this problem is to go to Device Manager and select the Modem card. Under Resources uncheck the Automatic Settings box, and select Basic Configuration 0000 . select IRQ and click Change Setting. Scroll through all of the available IRQs.
Write them down. Now select Input/Output Range click Change Setting, and scroll through all of the available I/O addresses. Write them down. Repeat for all I/O ranges.
Now select Basic configuration 0001 and do the same again for IRQs and I/O.
Continue until you have done all of the Basic Configurations.
Now you have to do the same for the controller.
Once you have this information you should be able to find nonconflicting IRQs and I/O addresses.
When you do enter the IRQ and I/O in the modem and leave the Automatic Settings box unchecked. Windows will object when you OK it. Tell it this is what you want.
Do the same for the controller.
Reboot.
This should solve the conflicts.
Regards, Chris
by csmith
I did not know that a cardwizard is posted on ibm.com. That is the way to go, (a lot easier,) if it there.
I forgot to mention this. If you are running Win95 OSR-2 , and you have to do a manual configuration, don't assign CD00-CEFF to the PCMCIA, it will create a conflict.
Regards, Chris
by shelby.boles
by mccabe
by shelby.boles
by xaqfox
by shelby.boles
by shelby.boles
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending