Discussion Locked

IDE CABLES

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I changed out a slot 1 ASUS motherboard on my computer. The replacement from EPoX a P2-133A has different IDE connections on the motherboard. The ASUS had a pin missing from one of the rows in each of the primary and secondary channel connections. The ribbon cable has a blank place to line up with the missing pin. The EPoX board has all the pins so the cable will not connect. There was one new cable in the motherboard box and it too had a blank space where one pin should fit. Any suggestions or is there a specific cable I should be looking for? Thanks.

11 replies

by tomsal

Hi.

To my knowledge all the IDE cables are still conforming to the same standard they have been for years and years and years. I know what you are talking about, I just built a system a few weeks ago as a matter of fact.

This will sound stupid, but bare with me....

Did you try turning the connection end of the cable "upside down" and then inserting it into the peripheral's (CDROM, Floppy, Hard Drive, etc.) pins?

You are using the right width cable right? There is a distinct and easily identifiable difference in width between a floppy's 34 pin cable and the standard 40 pin cable.

Of course there is a layman's method of figuring out the ribbon cable you need - simply count the pins on your mobo's primary and secondary channels. Its hard for me to say exactly what cable you need because I can't see your motherboard and I don't know (no disrespect) your level of expertise - people around here will mistake a floppy IDE ribbon for a HD's ribbon cable for example. Oh and remember that the red line on the ribbon lines up to pin 1.

But again, the standard IDE cable should work unless you are using new drive technology.

later.

by techkid

I have seen this before. Can't explain why some boards do it that way. You just need to buy new ide cables that work correctly... if the flipping of the cable doesn't work

by thechas

Be very carefull if you choose to implement this suggestion!!! Follow the old carpenters rule of measure twice, and cut once.

If you have a pair of side cutters that will reach into the connector, you can cut the extra pin out.

I have done this on a couple of MBs myself.

The keying pin is an unused pin, so as long as you cut the right pin, that will fix the problem.

I don't know why manufactures from time to time use headers with the extra pin. (Yes I do, it's cost and availability)

I don't think that you will find an ATA100 IDE cable that does not have the pin blocked. They just arn't common.

The other option would be to drill out the block on the connector. But you run a very high risk of damaging the cable.

by mdelyea

Get a large sewing needle, heat it up and melt the blocked pinhhole. Works for me.

This discussion is closed to new replies.