Discussion Locked

IDE Channels

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
If you are installing a Hard drive, CD, and a CD burner, what is the proper IDE configuration?

7 replies

by dmiles

The setup that I use
Primary IDE Controller
1)Hard drive= Master
2)CD-ROM = Slave
Secondary IDE Controller
1)Hard drive= Master
2)CD Burner=Slave
During my initial installation,reading the documentation,it was suggested to setup the CD burneras the Master on the secondary IDE controller,expiermented with this and it does not show the second drive in the post screen,switched the hard drive to Master and it performs okay
You will need to set the jumpers on the back of each device as shown for designated master or slave

by danpiers

Most IDE CD-Burners do require that you install them as the MASTER on the SECONDARY IDE channel. With that as a guideline, you have a choice of harddisk and CD-ROM on the PRIMARY channel or the harddisk alone on the PRIMARY channel and the CD-ROM as a SLAVE to the CD-Burner. There are pros and cons to each configuation. An older CD-ROM on the same channel with a new fast harddisk could reduce the performance of the harddisk. If the CD-ROM is a new 50+ speed model, or the harddisk is an older model, then this reduced performance may not even be an issue. If both the CD-ROM and CD-Burner are on the same channel, disk-copying performance will be greatly reduced. So, the bottom line is where you want the best performance. I personally make a lot of CD copies, so I make sure my CD-ROM and CD-Burner are on separate channels. My CD-ROM is only a 40-speed, but my older 20GB harddisk is not very fast either, so it works out good for me. Good luck.

by grump

You are using general terms as far as HD,CD
and Burner..
So, let us follow the standards...
Primary Master = Hard Drive
Primary Slave = CD ROM DRIVE

Secondary Master = CD BURNER

Your system looks for bootable device
starting first with the Primary IDE channel .
If you BIOS allows for boot from CD ROM it
must be defined in CMOS as to the boot order..

If you plan on coping CD TO CD then you will
have less problems with CD ROM drive on one
IDE channel and the CD Burner on the other..

And let's not even talk about UDMA mis-match
device conflicts with all the high speed data
transfer and cacheing that is going on...

Good Luck.. HD CD on other channel Burner

This discussion is closed to new replies.