Discussion Locked

IDE channels not Detecting connected dri

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I recently brought a brand new P4 titan GA-8IPE1000 motherboard. I installed everything booted up correctly until it got to detecting my IDE drives. (harddrive, DVD ROM, CDRW) I trieed changing some of the seting in the bios none of it seemed to make a difference. It almost like the drives aren't getting power. I checked all connetions and everthing appears to be fine. I also had the drives working in another commputer. The computers specs are as follows:
2.40GHZ 533FSB
GA-8IPE1000 motherboard
512MB of mircon DDR memory
GEforce 4 64MB Video card 440MX
Sound blaster live 5.1
motorolo 56K modem
Fujitsu 20 GB hardrive
12X/40X DVD ROM
LG 40X12X40 CDRW
600 Watt Power supply.
Can someone help me solve this problem thanks.

5 replies

by thechas

Look at your IDE cable.
Does it have a hole in it near one of the drive connectors?

If so, it is a cable select style cable, and the drive jumpers need to be set to cable select.

Next, try just 1 drive on each cable set to master only.

Is either drive detected?

Do you hear either drive spinning up and performing the drive self test?

If the drives do not perform their self tests, I would measure the power on the drive connectors with a voltmeter.
You should have 12 volts and 5 volts DC on opposite ends of the connector.

If the drives spin up and are not detected, you either are reading the IDE cable Pin 1 position on the motherboard wrong, or have a bad IDE controller on the motherboard.

Chas

by arielstarfire

Howdy.

Since you bought a new motherboard, and previously the drives worked on the old motherboard, but not the new one, lets try to rule out the drives as being bad.

Is that 600watt PS new? Try your old one first to see if it is a PS problem. Just because it's new doesn't mean it's good.

Set each drive for master, and test each one by itself on the primary and again on the secondary controller. Go into BIOS and try to autdetect the drive when its attached for the hdd. For the DVD and CD, you have to run thru the boot process to be sure it shows up and is detected. Make sure you enable the BIOS setting so you can see the boot up process. This process will tell you if both IDE controllers on the board are working along with the drive.

Setup: Test the setup for all 3 drives. You should put the HDD on Master, the DVDROM on slave, both on the same cable. Use a second IDE cable for the CDRW. This is the best setup, burners should always be by themselves.

If this fails, mimick exactly how you had the drives setup on the old computer. I had a computer the other day in the shop, that refused to recognize any of the drives unless the IDE cable was used backwards...long end and mid plug on the drives, short end on the motherboard. It wouldn't work the opposite of that which is the right way.

Good luck.

Ariel

This discussion is closed to new replies.