3 replies
by thechas
Most motherboards have 2 IDE connectors.
If you wish to copy CDs along with data files from the hard drive, your connections should be as follows:
Hard drive Primary IDE Master
CD Drive Primary IDE Slave
CD-RW drive Secondary Master or Slave
If your motherboard has an auxiliary IDE controller, I recommend the following:
Hard drive Auxiliary IDE Primary Master
CD Drive Primary IDE Slave
CD-RW drive Secondary Master or Slave
If you install a plug-in IDE controller card to gain additional IDE channels, I would still follow the above, as the new controller is apt to be faster than the one on the motherboard.
In addition to drive orientation and jumper settings, make sure that the DMA mode is set properly in BIOS settings for all drives.
Chas
by bjgt1
by bjgt1
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending