Discussion Locked

ide controllers

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My pc will not recognize my cd rom. In the system folder under device manager it shows a ! next to my primary IDE controller (single fifo) and my secondary IDE controller (single fifo). How do I correct the problem? When I double click on either of them and look at properties, it shows No Conflict?
Gary

5 replies

by richard_barsby

Hi you did not say which os you are using so I guess its win 95. You need the Mother board drivers disk that came with it if that does not help then visit the web site and down load them.

Hope this helps

Rich

by captng1

I am running win 98. I do not have the motherboard disk drivers . Where do I download them from?

by captng1

I am running win 98. I do not have the motherboard disk drivers . Where do I download them from?

by gazza-sa

It sounds like you have moved a hard drive that was already set up with windows, from one machine to another,
The way around this problem is to start the pc in safe mode, remove all, repeat all, devices from your device manager and then restart thepc and let windows find all the correct drivers.
You wll need to have your motherboard driver cd handy,
You also may need to install a temporary cd driver into your config.sys and autoexec.bat like we used to do back in the days of dos, do this toget access to the cd while windows sets up its drivers again.
Another way around this is to reinstall windows over the top of the current installation, but this is not always successful.

Hope this helps.

by rwlap

Another possibility is if you are running Win 95 or 98, and have a pentium II system, Intel posted a patch to correct motherboard and IDE controller problems - the original were not recognizing the correct 82371AB/EB Bus Master controller, and subsequently the primary and secondary controllers would show the "!" mark next to them. The other place to look is in system devices for the 82371AB/EB PCI to ISA bridge.
Hope this helps - one other point is you should have a master controller listed under the hard drive controllers and using the properties,settings, see if it is set for dual.
Lastly, is your hard drive on primary as master, and CDROM on secondary as master?

This discussion is closed to new replies.