Question Locked

IDE enclosure not recognizing

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I took the hard drive out of my old laptop when the motherboard died, and bought an IDE enclosure so I could retrieve all the data and to use the drive as a backup (external). When I plug it in via the Y cable it does not come up in my computer...or device manager. The instructions say you have to set the pins to "master" which involves a jumper shunt, which I don't have. Do I really have to get one and set it and then install it somehow?

5 replies

by seanferd

If the enclosure itself does not show up in Device Manager, you need a driver. Is the device supposed to work with the OS you are using?

If it is only the drive that is not recognized:

1) Go to Disk Management, select Drives, click Actions → Rescan drives. See if it shows up.

2) Laptop HDDs usually have a different (but similar) connector than normal HDDs. Does the enclosure have the appropriate connector? (Compare enclosure specs to your drive specs, available from your manuals or vendor's website).

3) You may or may not need the shunt. The drive should already be set to Master, as it was the only drive in the laptop.

However, look at the drive - there usually is a shunt on the jumper pins somewhere. Also, check the drive documentation - some drives are set to Master when no pins are jumped. You'll have to check for you exact drive model.

by older mycroft

One of the problems with external enclosures and NB hard drives, is that they fit together 'right way up' [b][u]AND[/b][/u] 'wrong way up'.

It is a common mistake that can cause a lot of needless head-scratching.

by seanferd

Dinnae ken tha'.

Thanks. I don't play around with NBs much.

by oh smeg

Most likely yes you do need the jumper, but here it depends on the HDD maker and how they made the drive.

Some Drives need to be set to master and some don't, Here it depends on the actual Drive.

However the other thing to look for is the actual Y Cable here. The USB Plugs are not the same if you look closely at the lead you will see that the USB Plug on the end of the lead has a finer wire going to it this is because it is a Power Only Plug while the one in the middle of the Lead is a Power & Data Plug.

You should plug both of these USB Plugs into different USB Ports to get enough power for the HDD in the Enclosure and have a Data Connection to the Computer. You may also be required to install a USB to IDE Driver that came with the enclosure if there is one as well.

Also any Computer shop should have the necessary Jumper in their Techs Junk Box so if one is required it's a simple matter of just asking the Local Tech for one. ;)

Col

This discussion is closed to new replies.