Discussion Locked

IDE transfer modes

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

If I set my IDE drives up like this:

Primary master = 9gbHDD ATA-100
Primary slave = CD-Rom UltraDMA/33
Secondary master = 40gbHDD ATA-133
Secondary slave = CD-RW UltraDMA/33

what effect will the CD devices have on the transfer rate?

It seems like in this setup, the HDD transfer rate for each channel would only be UltraDMA/33, not ATA-100. Doesn't each IDE channel revert to the lowest common transfer speed?

Is this correct?

6 replies

by opatzg9

Thats what I've read in other posting here, an answer may be to install a pci ide card for the hdd and leave the cd's on the motherboard as masters there.

by deadly ernest

As a general rule each IDE channel will work only at the speed of the slowest device on it. Also the higher speeds will only be available if you have 80 pin cables.

Best speeds would be obtained by having a 80 pin cable connecting your two HDDs on one channel (say the primary) and both CD devices on the other channel. Thus you would have ATA 100 on the hard drives and ATA 33 on the CDs. This would triple you hard drive operation speed.

This discussion is closed to new replies.