Discussion Locked

Identify the type of NIC in a computer

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How I can identify the type of NIC that is in a network computer without taking the card out and examining it? I want to know if the cards in our system are 10base-T or 10/100 LAN cards. I heard that if the card has a BNC connector on it, that it's a 10base-T card.

11 replies

by bigjedi20

A BNC connector has a maximum of 16Mbps. If the card has both connectors, then it's possible that it could be 10/100. The only way for sure is to plug it into a 10/100 hub and see what color light comes up.

by vertex

The NIC can be identified at Device Manager under Network Adapter. There's bound to be some description of your NIC there.

by tlm

The anwer #1 is half correct. Inorder to get a true reading from the hub. The hub itself would have to be a 10/100 auto switching hub. Also for a 100mb card to connect at 100mb it has to have the correct type of cable. The cable must be at leastcat 5 24awg & the hub must have 100mb ability. If you have the disk that came with the card there should be a test utility.

by toltec58

Go to a command prompt -
Type - "ipconfig /all" -if NT or 2000
"winipcfg /all" -if win9X
Should say fast ethernet if 10/100

T58

by ddickerson

Depends on the operating system. Win 95/98 right click my computer go to properties then to network adapters. Double click the adapter and it will give you the card type that you can check the speed with the model number. Win NT right click network neighborhood go to properties adapters and card type is there. It may say the speed in the description or you might try in the adapter bindings (win 9x only) to see if you can switch from autosense to 10mbps or 100mbps. In NT check properties for theadapter. If no option its most likely 10mbps card.

This discussion is closed to new replies.