Question Locked

identifying cat6 cables in the hubs

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We have a building of about 25 pcs and 3 dumb terminal users. On the wall next to everyone's desks is a RJ45 socket with a number on it e.g. A17 and in our computer room we have 2 hubs labelled Upper and Lower, each has about 40 ports on them.

I have a cable tester which I could plug into the cat6 cable next to the users computer desk and locate the cable plugged into the hub and detect which is the correct end to the length of cable but unplugging 25 cables for every user is a pain in the neck.

Is there a simpler way either by another piece of hardware or software that could do it? And if so what is it and where can i get it?

And yes we should have noted all connections when the hubs were first installed but we didn't.

Thanks
bruce

6 replies

by toivo talikka

I have seen cable technicians connect their transmitter to the outlet at the workstation and scan the outside of the patch panel with a kind of a wand which starts beeping when it is pointing at the right outlet. I do not think it had to be inside the jack to do that. That must have been a different type of device than your tester.

One way to produce the cabling diagram is to disconnect the flyleads at the workstations, one at a time, and check at the two switches (yours must be switches, not hubs) which light is off, then follow the patch lead to the patch panel and document both ports.

by bldsm

I thought of this but found that found that even when the PCs were off some of the hub lights remained on and flashing. Other PCs when off showed no light on the hub. I thought I could do that, shut them all off and turn one on at a time to ID the right port but didn't work.

by toivo talikka

...because even if the PC is turned off but it is not disconnected from the power source, the network card may still have power.

If you disconnect the flylead from the PC or from the wall outlet, there is no way the hub light could be on.

by cg it

unless the cable guys left a diagram of their labeling ,,, the only sure way is to use a cable tester.

Also depends on which switch your using. If it's a Cisco, you could find out by IP address which comp is on what port

also depends on whether the cable from each station goes to a patch panel and then from the patch panel to the switch or the cable from the station goes directly into the switch. There are cable testers that will blink the switch port light but others that just test the wiring at the RJ-45 connector need a loop to work. Also if the line is active it'll burn the unit out or flood the network.

http://ideal.datacomtools.com/idealcatalog/twisted-pair-cat5.htm

This discussion is closed to new replies.