Discussion Locked

Improper CPU external speed setting

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

AMD Athlon 900MHz SA 256k Cache 200 FSB Processor
Dane Elec 256 MB PC133 SDRAM Memory
ASUS A7V-E MB with integrated audio
ASUS V7700 Pure Nvidia GeForce 2 GTS AGP 4x 32MB DDR Video
Maxtor 30.7 GB ATA/100 7200 8.7ms 2 MB Cache HDD
MS Windows98SE -- IE 5.5 Sp2

BIOS screen pops up at bootup with this message
"During the last bootup, your system hung for an improper CPU external speed
setting. Your system is now working in Safe Mode (Bus: 100Mhz, DRAM:
100Mhz, PCI: 33 Mhz). To optimize the system performance and reliability,
make sure the CPU speed conforms to the specifications of your CPU.
Since I do not know how to set this in the BIOS, I loaded and saved BIOS
defaults, and booted up.
Can you help?
Thank you.

8 replies

by dmiles

If you are not familiar with the CMOS panel to open,you will need to reference the motherboard manual,which will show the configuration panel and how to set the proper settings
Boot computer,at Startup screen in lower left corner it will show key to press to enter setup,once key is pressed and the panel is shown
Use the arrow keys to navigate to the CPU setting,then press enter to select the correct CPU speed,if this is confusing navigate down to Bios default settings and select it then save and exit,reboot

by thechas

The A7V has 2 ways to set CPU speed.
There are 2 banks of switches and jumpers for CPU speed and clock settings.
I recommend that you set up your board for "Jumper Free" mode.

If you do not have the manual, download it from ASUS's web site.

Set all switches on DSW to off.
Set the CPU voltage jumpers "VID" to position 3-4
Set "JEN" to 1-2
Set "VIO" to 2-3

Then, in the BIOS settings in the Advanced section, make sure that all the CPU settings are set to auto or default.

That should take care of the problem.

The ASUS manual does give you very good detail on each of the BIOS settings. It is worth taking some time to read it over.

by thechas

If you want to set the settings, use a 133MHz buss setting;
Set the Multiplier to 6.5
Check with AMD, and set the core voltage to the appropriate voltage for your CPU.

by mdelyea

Asus motherboards have a jumper on them to set CPU speed automatically. If this jumper is not set for auto you must manually set the bus speed and multiplier. The message you got is common for the first boot of a new cpu/mobo combo. Press del when prompted during the POST and go to the CPU area. The bus should be set to 100 (not 133) and the multiplier should be set to 9.0. If you do not plan on overclocking it is simpler to set the mobo jumper to autodetect the CPU.

by dosdummy7

Thank you. the system is 8 months old, and this is the second time this happened. I guess I will have to mess with the BIOS (feeling kind of queasy about it):o(
Renate

This discussion is closed to new replies.