3 replies
by jschein
Ok... things needed...
1) Hard drives?
2) Cr-Rom drives?
3) Running latest bios?
1... Ensure the hard drive on the end of the ide cable is set to MASTER, drive in middle is set to SLAVE.
2... Same scenario as 1, BUT if they are used drives and are setup as # 1, then one of those drives has gone bad.
3... Lookup your motherboard online. Look at the latest bios and see what it resolves. If it discusses your problem, download it and install it.
Good luck
by ameliapumo
1. Put boot disk foro/s in floppy drive
2. Only connect Hard drive in IDE1 and CD on IDE 2
See if they are both recognised (ignore whAT THEY ARE REGOGNISED AS)
FOLLLOW INSTRUCTIONS IF BOTH RECOGNISED AND CABLES oK YOU HAVE A PROBLEM ON DRIVE.( i KNOW THIS AS I HAD SAME PROBLEM. tRIED PUTTING DRIVES ON DIFFERENT CABLES, SETTING THEM AS SLAVES, THEN MASTGERS, ETC. eVENTUALLY FOUND THAT THE hARD DRIVE WAS FULTY, EVEN THOUGH BRAND NEW)
BEST ADVICE IS TO TRY DRIVES ON A FRIENDS PC TO SEE IF THEY WORK THERE. ANYTHING AFTER 1998 SHOULD WORK ON ANY PC AND AUTO DETECT.
by wlbowers
Sounds like you have your jumpers set wrong. Set all of the drives as cable select.
Start with one hard drive on the main ide controller and one cdrom on secondary ide controller.
Now boot your machine. Test and install your os. Once you have it up and running add hard drives one at a time.
Good Luck
Lee
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending